Pocatello Amateur Radio Club Repeater help                                                                PARC - home page

PARC owns and operates two 2 meter FM voice repeaters, 
Kinport and Scout Mt. As well as an APRS digipeater.  Read down the page for 147.36

PARC   147.060mHz Scout Mt.   +600kHz Offset, 100Hz PL .   
for more pictures 2008 work party  or  install 2002

Located 14 miles south of the intersection of I-15 and E. Center street,  Exit  (69)
It is open to all users,  It is solar powered.  It has NO  function other than a basic voice repeater.
PARC Pays the US Forest Service over $120 a year to rent the mountain top location, your dues are important in keeping this radio on the air 

Please  :    Help conserve battery power,  if possible,
especially in the winter months, use simplex ..or .36
if your not in simplex  range, feel free to use the repeater.
It is a GE Master Executive II  , installed 2002 K9GP, AC7LI, KIP

 

                                 

Homebrewed  Talking controller, QST  project    Feb 1997 issue (?)                  Cavities and charge controller inside shelter.

Solar array for charging the batteries,   There is NO commercial power on Scout Mt.

  
END END END of 06 information


147.360mHz N7PI /R repeater - Kinport           (parc home page Link)
& the APRS digi-peater on 144.39 
                                                                                                                                                         

Mt. Kinport  located 6 miles SW of the I-15 Center Street Exit (69) at 7200 feet.
It operates on 147.360 +600kHz offset  ... 100Hz Pl required

This repeater has a 10 meter FM Link on 29.600mhz

LINK Information.  please understand,  29.600mHz is 10 meters.. This is the FM Calling frequencies.
10 meters does have world wide propagation (at times),  so if your setting around, with nothing to do
turn the link on and see if anything is bouncing off the ionosphere .  

How to tell which band a signal is on
if  the link is on
a station on 10 meters will cause a Hi & Low Beep,  "like" a  BEEP BOOP sound.. ,  at the end of his transmission 
a 2 meter station will cause a single beep at the end of his transmission ,  Which also indicates the 3 minute timer has been reset.

 

    When a Link is on, any traffic or QSO occuring on 2 meters is transmitted on 10 meters as well as two meters
    if someone out there in "radio land"  hears you, you'll probably have breaking station wanting to take advantage of the propagation.   
 

Codes   010 turns 10 meters,
            000 turns OFF
10m turns

other test codes   123  tests your audio. 
 
Press 123, unkey your radio, repeater says "ready", Key your radio and make a test transmission, when you unkey it will be play back.
 

AUTO UN - LINK, be advised.
When you press 000 it will turn off the 10 meter link
or if you just leave the link on it will automatically unlink after approximately 4 hours,
No warning, it just happens.....  it could be in the middle of your QSO,
this timer can be reset at any time by pressing 010 .