147.360mHz N7DN/R repeater ,        
Repeater with Autopatch, and IRLP radio link..

PARC owns and operates two 2 meter FM voice repeaters,  This page  cover's KINPORT .. 
As well as an APRS repeater. And maybe more in the near future.

These repeaters are paid for with DUES.. so if you are a regular user of our equipment, you might think about
joining our club.  Just a thought..?

Mt. Kinport  located 6 miles SW of the I-15 Center Street Exit (69) at 7200 feet.
It operates on 147.360 +600kHz offset  ... NO PL Tones.  

the 147.36 repeater, is working, but at best,  ONLY working

The repeater receiver is very insensitive,

SO  if you want to use it, you need more power than a  2 watt HT !


THIS  repeater is  a 'remote base'  anything you say on 2 meters goes
out on 52.525mHz, that's the 6 meter FM calling frequency.  Also, if there is a signal
on 52.525mHz it translates to 2 meters. This function is turned on, and will remain on at least
for the present time. Six meter does open much for FM into our area. BUT it could open ?? 
so if you hear strange calls, don't be shy, get in there and work some DX. 
I'm sure they will be glad to hear Idaho.

 

Please note, you will NOT get a Squelch tail or ID  if you  key up on 52.525 but you should
hear your signal on 147.36.

 

 

 

 

STOP  !!!!!!!!!!!!           IRLP and AUTOPATCH are NOT working..  

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

How to use the IRLP, worldwide internet link.  

1. touchtone in the 4 digit code of the remote IRLP system you want to communicate with..

     Get Codes Here
   

2. Give a call

3. when finished press 73 to disconnect the connection.

notes:
The  IRLP system, is a radio to radio contact,  everyone is using a radio.
Remember this is Ham radio, so act according.

 

here are a few other codes you might want to know,, when using the system, please ID yourself..
11 - Checks to see if the IRLP node is busy.
12 - Time check
13 - Temperature check
69 - Last incoming and outgoing call

 

How to use the AutoPatch. !!

the Kinport machine has an  open autopatch,  
Just dial *0  listen for the dial tone, Key your radio,  dial your number.
there is a 3 minute timer. keep it short. then press #0 to turn it off.

 

AUTO DIAL NUMBERS programmed into the autopatch!
Dial *0 to get dial tone --- dial #0 to turn it off.
AutoDial numbers are :
9*0 Bannock County Sheriff
8*0 Pocatello Police
7*0 Chubbuck Police
6*0 Idaho State Police
5*0 Power County Police
4*0 Bingham County Police
3*0 Bonneville County Police
2*0 Butte County police
1*0 Caribou County Police